press the [ENT] button.
6.
Select the listing “0, 1,5” to configure for RAID Level then press the [ENT] button.
7. Press the down arrow [
▼
] button until the “13 Disk Number” menu is displayed then
press the [ENT] button.
8. Use the down arrow [
▼
] buttons to select the number of disks to configure for the
ACS-8910 then press the [ENT] button.
NOTE
: This disk number does not include “hot spare” disk.
9. Press the [ESC] button to return to the “Main Menu” menu.
10. Press the down arrow [
▼
] button until the “2 SCSI Params” menu is displayed then
press the [ENT] button.
11. Press the down arrow [
▼
] button until the “21 Set SCSI ID” menu is displayed then
press the [ENT] button.
12.
Use the down arrow [
▼
] button to select a SCSI ID to set the ACS-8910 then press
the [ENT] button.
NOTE
: The default setting is SCSI ID 0.
13. Press the down arrow [
▼
] button until the “22 Termination” menu is displayed then
press the [ENT] button.
14. Use the down arrow [
▼
] buttons to enable or disable the SCSI termination for the
ACS-8910 then press the [ENT] button.
NOTE
: If the
Condre RAID
is the only SCSI device on the bus or is at the end of a
daisy chain the termination should be enabled. If the
Condre RAID
is in the middle of a
daisy chain the termination should be disabled.
15. Press the down arrow [
▼
] button until the “23 Tag Queuing” menu is displayed then
press the [ENT] button.
16. Use the down arrow [
▼
] buttons to enable or disable the Tag Queuing for the
Condre RAID
then press the [ENT] button.
NOTE
: The default setting is Tag Queuing is “Enabled”. Tag Queuing allows the
Condre RAID
to process multiple requests thus improving performance.
17. Press the down arrow [
▼
] button to select the “224 Ultra ” and “ 225 Wide” menu.
18.
Follow next list to setup SCSI interface of Host.
Speed/Wide
Wide
Fast
Ultra
Ultra2
Ultra 3
SCSI Interface
SCSI-2 Disable
[ENT]
Wide SCSI
Enable
[ENT]
Ultra SCSI
Disable
[ENT]
Ultra Wide SCSI
Enable
[ENT]
Ultra 2 SCSI
Enable
[ENT]
Ultra 160 SCSI
Enable
[ENT]
19. Press the [ESC] button to return to the “Main Menu” menu.
20. Press the down arrow [
▼
] button until the “5 NVRAM” menu is displayed then press
the [ENT] button.
22