![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056008.webp)
In order to protect the operator from possible harm from the
rotating blade wheel, several safety features are built into this
cutter. They include:
Two electric switches make a contact between the side
and the clear polycarbonate sliding blade observation
windows such that the windows MUST BE CLOSED
in order to enable the blade wheel to spin.
●
●
This prevents someone from opening the windows and
having the blade wheel spin which can cause serious
injury. Tampering with this safety feature will VOID
ANY responsibility for safety.
A proximity switch is positioned on both the upstream
and downstream side of the bushing holder. If there
are no bushings in either side, the blade will not spin.
●
●
This prevents someone from inserting their hands or
fingers in the cutting mechanism while the blade wheel
is spinning. Tampering with this feature will also
VOID ANY responsibility for safety.
A safety switch is positioned on the bushing holder flip
up guard to prevent operation unless fully closed.
●
●
This prevents someone from inserting their hands or
fingers in the cutting mechanism while the blade wheel
is spinning. Tampering with this feature will also
VOID ANY responsibility for safety.
A lockable main power disconnect is provided to pre-
vent the possibility of hazardous electrical shock while
servicing the main electrical enclosure. (See How to
use the Lockout Device, in Section 1)
SC-5 SURE CUT Servo Knife Cutter
UGE059/1003
1-4
I
NTRODUCTION
WARNING: Voltage Hazard
This equipment is powered by three-phase
alternating current, as specified on the machine
serial tag and data plate.
A properly-sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the electri-
cal enclosure. Improper grounding can result in
severe personal injury and erratic machine
operation.
Always disconnect and lockout power before
opening the electrical enclosure or performing
non-routine procedures such as maintenance
and service.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
CAUTION: It is always recommend
that the main power cord be dis-
connected and placed in clear view
of the operator or service person-
nel while changing blades or ser-
vicing the cutter in any capacity.