![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056044.webp)
SC-5 SURE CUT Servo Knife Cutter
UGE059/1003
4-10
O
PERATION
Exit or Prev, if no change is required press Exit or
Prev to return to the Main screen.
Raise will increase the preset by 0.010 inch. The key can be
pressed once for each 0.010 inches increment required or held
down to scroll up. Releasing the key will freeze the preset at
the last value then press enter.
Lower will decrease the preset by 0.010 inch. The key can be
pressed once for each 0.010 inch decrement required or held
down to scroll down. Releasing the key will freeze the preset
at the last value then press enter.
Numeric keys
Key in the length required and press enter. The decimal place
is fixed so remember this when entering the preset. If you
require 24 inches you must key in 24000 and then press enter.
Keying only 24 will set the length to 0.024 inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it to
be accepted and return to the Main screen. If it is wrong press
the delete key and the previous preset will reappear.
PRESETS TO RUN SCREEN
By pressing the soft key located under the word #Prst on any
Length Screen, the value for the number of presets to run is
available. Additional information on how to access this screen
can be found on the multiple preset example in the operator
display overview in Appendix E of this manual.
The number shown is the current number of presets to run
value, i.e. how many measurement presets and batches to run.
The acceptable range for this value is 1 to 4. The cutter will
process preset#1/batch#1 then #2 then #3 then #4 and back to
#1 continuously. If a 2 is entered only preset/batch 1 and 2 are
processed. A cursor will appear in the least significant digit.
The user has a choice of ways to adjust this number.
RUN 4 PRESETS
Exit
C
ONTROL
I
NSTRUCTIONS
P
RESET TO
R
UN
S
CREEN
Continued
C
ONTROL
I
NSTRUCTIONS
L
ENGTH
S
CREEN
C
ONTINUED