![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056075.webp)
Follow all warnings and cautions listed at the beginning of the
Maintenance section of this User Guide.
Be sure the main power is disconnected
and the
cutter is locked out.
Loosen the set screws
that hold the cutter bushings.
Remove the cutter bushings.
Check the depth of the proximity switch
face for each bushing
. It should be recessed no more
than 0.010 inches, but should not interfere with the bush-
ings themselves.
Check the tightness
of each proximity switch's
retaining screw
. Use an Allen wrench to perform this
task.
IMPORTANT: You can damage the proximity switch if
you over-tighten the retaining screw.
Replace cutter bushings
and check for proper cut-
ting blade alignment. See Mounting the Cutter Bushings,
Section 3 and the Appendix A and C.
Plug in the power cord
and turn the main power dis-
connect to the on position if all other maintenance is com-
pleted.
A
DJUSTING THE
P
ROXIMITY
S
WITCHES
UGE059/1003
SC-5 SURE CUT Servo Knife Cutter
M
AINTENANCE
5-9
2
1
3
4
6
7
5
Proximity
switches