![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056023.webp)
You need these tools for installation:
❒
wire strain relief
❒
16- or 18-inch adjustable wrench
❒
set of Allen wrenches
❒
set of feeler gauges
❒
½ inch open or box end wrench
❒
flashlight
Plan the location.
Make sure the area where the
servo cutter is installed has the following:
●
A grounded power source. Check the cutter’s seri-
al tag for the correct amps, voltage, phase and
cycles. All wiring should be completed by qualified
personnel and should comply with your region’s
electrical codes.
●
Clearance for safe operation and maintenance.
Make sure there is enough clearance around the
servo cutter for maintenance and servicing. If the
servo cutter has the optional slide base, be sure to
check for clearance by extending the slide system in
both directions.
P
REPARING FOR
I
NSTALLATION
UGE059/1003
SC-5 SURE CUT Servo Knife Cutter
I
NSTALLATION
3-3
1
2
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.