![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056028.webp)
SC-5 SURE CUT Servo Knife Cutter
UGE059/1003
3-8
I
NSTALLATION
I
NSTALLING THE
C
UTTER
B
LADES
DANGER: Sharp blades!
Most injuries caused by knife blades occur
when the cutter has been turned off. Handle
blades with care at all times.
●
Always lock out power to the cutter before
opening the cutting chamber.
●
Always wear cut-resistant gloves when the
cutting chamber is open and when handling
blades.
●
Always wait until the cutter head has com-
pletely stopped before opening the knife
guard.
SC-5 Sure Cut cutters are equipped with sever-
al safety devices to ensure safe operation.
Never remove or disable these devices to sus-
tain production. Operating without these devices
can cause severe injury.
Never attempt to change or work on Blades
without first locking out power to the machine.
●
When the knife guard is opened, the
knife guard switch stops the cutter.
●
Two proximity-type safety switches prevent
operation unless the cutter bushings
are in place.
●
The STOP button activates a circuit that
stops the cutter head.
Installing the Cutter Blades
Shut off the main power disconnect and
unplug the main power cord
when entering the
cutter housing. There is a safety interlock on the cutter
blade housing that will deactivate the servo amplifier and
control system.
Remove the screws holding the blades,
remove the old blades and insert the new
blades.
The blade, or blades as the case may be, will fit
onto a roll pin or in a machined slot with a blade
clamp to squeeze or tighten. Secure the blade.
For more information about choosing the appropriate blade for
your material, see the Appendix B.
1
2
Continued