![background image](http://html.mh-extra.com/html/conair/sc-5-servo/sc-5-servo_user-manual_2649056033.webp)
UGE059/1003
SC-5 SURE CUT Servo Knife Cutter
I
NSTALLATION
3-13
Make sure all components
are installed according
to assembly drawings. Make sure that all bolts on the cut-
ter have been tightened.
Check that cutter is firmly locked
into position
with the anchoring screws.
Check that all wiring conforms to electrical
codes
, and all wiring covers are in place.
Locate the main disconnect switch on the front
of the control cabinet.
Turn it on. You should see the
Redlion interface illuminate and start communications
and the yellow power light should now be on.
Make sure the bushings and the blade doors
are in place and secure.
Check that the bushing
access door is closed and the threaded knob is tight and
the E-stop is in the out position.
Press the green start button.
If the guard circuit is
ready the green start button will now be illuminated.
Do a test cut, by pressing the black manual cut
button.
You should have caused the flywheel to com-
plete on test cut.
To enable the cutter, push the center arrow
key.
If for any reason any of these steps could not be achieved
please refer to the troubleshooting section of the manual.
1
2
P
REPARING FOR
T
ESTING
1
3
T
ESTING THE
I
NSTALLATION
2
3
4
5