Comtech EF Data MetaCarrier MCDD-100, Installation And Operation Manual

Page: 58 / 88

MCDD-100 MetaCarrier Detection Device Revision 3
Serial-based Remote Product Management MN-MCDD100
5–8
5.3 Remote Commands and Queries
The Serial Interface (the Controller), shown previously in Figure 5-1, is used to issue remote commands and queries to the MCDD-100
(the Target). From the Serial Interface command prompt MCDD-100> type in the command or query packet, using the format explained
previously, for transmission to the MCDD-100.
For example: MCDD-100><0000/IPA=010.006.030.001/24 [cr]
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the MCDD-100. The ‘C’ and
‘Q’ columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only , Query Only , or Command and Query .
INSTRUCTION CODE USED TO... C Q Page
DPW Resets the admin username/password to the factory defaults X 5-9
IPA Set or query the IP Address and network prefix for the Management | FE port X X 5-9
IPG Set or query the IP Gateway Address for the Management | FE port X X 5-9
These Instruction Codes are explained in complete detail in the tables that follow. Note that the Target-to-Controller Instruction Code
Qualifiers, described earlier, that appear in the “Response to Command” column carry the following meanings:
= Message OK.
? Received OK, but invalid arguments were found.
* Message OK, but not permitted in current mode.
# Message OK, but unit is not in Remote mode.
! Invalid instruction.