Comtech EF Data CDM-710G, Installation And Operation Manual

Page: 199 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Remote Control MN-CDM710G
A–9
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Faults and
Status
N/A 4 bytes Query Only.
Unit returns the current fault and status codes for the Unit (hardware), Tx
Traffic and Rx Traffic, in the form abcd, where:
a = Unit Faults:
0=No faults
1=Framer FPGA Load
2=Power supply fault, +1.5 Volts, Framer Card
3=Power supply fault, +1.5 Volts, Interface #1
4=Power supply fault, +1.5 Volts, Interface #2
5=Power supply fault, +3.3 Volts, Framer Card
6=Power supply fault, +5.0 Volts, Framer Card
7=Power supply fault, +12.0 Volts, Framer Card
8=Power supply fault, -12.0 Volts, Framer Card
9=Power supply fauilt, +18.0 Volts, Framer Card
A=FLASH Checksum
B=FEC1 Load
C=FEC2 Load
D=Interface #1 Load
E=Interface #2 Load
F=192 MHz PLL
G=External Reference
H=Framer Card Temperature
I=Modem Temperature
J=Cooling Fans
K=Interface #1 Removed
L=Interface #2 Removed
b = Tx Traffic Status:
0=No faults
1= +1.5V Power Supply Unit (Modulator Card)
2= FPGA Failed to Load (Modulator Card)
3= Symbol Rate PLL Clock
4= Tx Synthesizer Unlocked
5= Tx Digital Clock Manager Unlocked
6= I & Q Baseband Channels are Inactive
7= FPGA Temperature (Modulator Card)
8= Reserved
9= TX Clock Failure (Interface 1)
A= TX Clock Failure (Interface 2)
B= GBEI Card Data rate > + 200 PPM
C= GBEI Card Data rate < - 200 PPM
D= GBEI No PHY Link
E= Encoder FIFO Empty
F= Encoder FIFO Full
G= SERDES Parity Errors
H=Reserved.
FLT?
FLT*
FLT# FLT? FLT=abcd
d=Change in fault status
since last poll.
Note: Each section has
faults listed in order of
priority. For each
section, only the highest
priority fault is returned.
There maybe multiple
faults for each section,
but only the highest fault
is returned.