Comtech EF Data CDM-710G, Installation And Operation Manual

Page: 174 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Single G.703 (E3/T3/STS-1) Interface (CDI-10-1) MN-CDM710G
12–4
12.4 Summary of Specifications
Item Requirements
General
Interfaces 1 each Independent G.703 ports, E3, T3, and STS-1
External Clock Input 1 input
Interface Selection Each of the interfaces is individually enabled
Rx Buffer: G.703 Frame Types
Type Bits Bytes
G.751
G.752
G.753
STS-1
1536
4760
2148
6480
192
595
268.5
810
Note: Programmable in 0.5 ms increments.
Minimum Buffer Size for any rate 0.5 ms
Maximum Buffer Size
G.751 61 ms
G.752 44 ms
G.753 61 ms
STS-1 40 ms
Clock Options
Tx Clock = Tx, Rx (satellite) or External
Rx Clock = Tx, Rx, External or Internal
Note: Asymmetric operation is not supported
Acquisition Range
Programmed Tx data rate
±
100 ppm
Test
Baseband Loopback (at interface)
Interface Loopback (through interface module)
Hot Swap Capability None
Interfaces
G.703 Unbalanced:
Connector Type
Signals Supported
Data Rate
Tx and Rx Data Rates
Line Coding
Pulse Mask
Jitter
Impedance
1 independent channel supporting G.703 E3, T3, and STS-1.
BNC, female
ITU-T-G.703 SD, RD
34.368, 44.736 and 51.84 Mbps
Tx and Rx data rates are programmed the same
HDB3 (for E3), B3ZS (for DS3 STS-1), AMI (Common)
ITU-T-G.703
Bellcore GR-499 core For T3 and STS-1, G.823 for E3
75
Ω
Per ITU-T-G.703
External
Clock
Input
Connector
Impedance
Input Amplitude
Input Frequency
Signal Characteristics
BNC, female
75
Ω ±
5%
0.5 to 5.0 V peak to peak
1, 2, 5, 10, 2.048, 34.368, 44.736, and 51.84
Sine wave or square with duty cycle of 50
±
10%
Alarms
Loss of Signal
All 1’s
Physical and
Environmental
Environmental
Humidity 0 to 50 °
C (32 to 122
°
F)
Temperature 0 to 95% non-condensing
Dimensions
3.95 W x 8.14 D x 1.5 H inches
(10.03 W x 20.67 D x 3.81H cm)