Comtech EF Data CDM-710G, Installation And Operation Manual

Page: 113 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–37
6.3.1.9 CONFIG: Alarms
Note: When the unit is in Remote mode and the user attempts to select an alarm state using the
W X
arrow keys, the following message displays (follow the prompt as shown):
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
DO YOU WANT IN LOCAL
MODE?ENT=Yes CLR=No
Otherwise, the following menu is displayed:
Alarm Mask: Tx Rx
Intfc1 Intfc2 (
E)
Select Tx , Rx , Intfc1 , or Intfc2 using the
W X
arrow keys, then press
ENTER
.
(CONFIG:) Alarm Mask:
Æ
Tx
Tx Alarm Mask: None
Currently, masking of Tx Alarms (associated with the modulator) is not allowed.
(CONFIG:) Alarm Mask:
Æ
Rx
Eb/No Threshold Alarm:
Alarm Fault Mask (
E)
Select Alarm , Fault , or Mask using the
W X
arrow keys, then press
ENTER
.
(CONFIG:) Alarm Mask:
Æ
Intfc1
The appearance of the menu branch for CONFIG: Alarms (Alarm Mask:) Æ Intfc1 is
dependent on whether the CDI-10-1 Single G.703 or the CDI-60 HSSI Interface card is installed
into Interface Slot 1.
Intfc1 E3T3STS1 Alarms:
Tx Rx ExtClk (
E)
Intfc1 HSSI Alarms:
Port1 Ext-Clk (
E)