Comtech EF Data CDM-710G, Installation And Operation Manual

Page: 157 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Clock Modes MN-CDM710G
10–3
UNBAL
UNBAL
G.703
E1/T1
E2/T2
G.703
E1/T1
E2/T2
Ext
BAL
Clock
Ext
BAL
Clock
UNBAL
E3/T3/STS -
1
Processor
Mux /
Demux
PLLs
Rx
Buffers
Interface
Loopback
Processor
Mux /
Demux
PLLs
Rx
Buffers
Interface
Loopback
Modem
Interface
Tx
Rx
Clk
&
Data
μ
C
BNC Female 3 Places
J3
J2
Single E3/T3/STS -1 Card
Loopback
EXT Clk
J1
External Clock
10.2 CDI-10-1 Single G.703 Interface
The CDI-10-1 Single G.703 interface has a single port that operates at an E3, T3, or STS-1 data
rate. A port is a Tx/Rx pair.
Figure 10-2 shows the interface.
Figure 10-2. CDI-10-1 Single G.703 Interface
10.2.1 CDI-10-1 Single G.703 Interface Transmit Clocking
For the G.703 interface, the only clock allowed is the SD signal applied to the Tx input. Internal
Clock and Rx Loop-Timed operation do not apply to G.703 applications.
10.2.2 CDI-10-1 Single G.703 Interface Receive Clocking
When the Rx Buffer is disabled, the receive clock is the Rx-Sat. In this mode, ensure the Rx
Buffer is set to minimum to reduce latency.
When the Rx Buffer is enabled, the Rx clock selections are as follows:
Rx-Sat (default)
Selecting this clock disables the Rx Buffer because the input and output clocks
are both Rx-Sat. Normally, the Rx Buffer is set for minimum when Rx-Sat is
selected.
Tx-Terr
Uses the clock from the Tx input (SD) to clock out the Rx Buffer. The Tx and
Rx data rates are the same on this interface, so asymmetrical data rates
where Tx
≠
Rx is not permitted. The two data ports are independent, so Port 1
may have a different data rate than Port 2.
Ext-Clk
Derives a clock from a signal input to the Ext-Clk connector on the
E3/T3/STS-1 Interface Module, not J7 on the modem.