Comtech EF Data CDM-710G, Installation And Operation Manual

Page: 76 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Flash Upgrading MN-CDM710G
5–4
9.
Transfer
the files.
Type "
put FW0000114*.bin bulk:
" to begin the file transfers. The destination “
bulk:
” must
be all lower case. It will take approximately one minute to transfer the file.
10.
Verify
the file transfer.
a. The PC should report that the file transfer has occurred, and the display on the
modem will report:
Programming flash sector #xx
Please wait…
b. The process sequences through several blocks – this will take several minutes. When
it has finished, the modem front panel will display:
Bulk FTP done. Press CLEAR.
c.
Terminate the FTP session
by typing "bye" and closing the DOS window.
d.
Verify
that the new file loaded using the procedure in Step 1.
e.
Change
the desired image to boot from the modem font panel menu:
SELECT: UTIL
Æ
Firmware
Æ
Select
and use the left or right arrows ( ◄► ) on the front panel
keypad to change to the other image,
then reboot the modem.
f.
Verify
the new software versions are booting by observing the following messages
on the modem display:
CDM-710G Modem
Firmware Ver x.x.x
5.3 10/100/1000 BASE-T (GigE) INTERFACE (CDI-70) FTP Upload Procedure
Refer to
Chapter 14. 10/100/1000 BASE-T (GigE) INTERFACE (CDI-70)
for information on
and instructions for flash upgrading this optional data interface.
5.4 USB Procedure
IMPORTANT
USB reflash is not available in this firmware release – please consult Comtech
EF Data Customer Support for release schedule.