3-6
Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Compaq Confidential – Need to Know Required
Writer:
Rachel Williams
Project:
Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Comments:
Part Number:
221544-001
File Name:
d-ch3 Installing Software.doc
Last Saved On:
12/27/00 10:59 AM
25.
Create a firmware diskette at this time if you are completing this step on
node 1. You will use this diskette later to upgrade the RA4000 controller
firmware. If you are performing this procedure on node 2, skip this step
and continue with the following section “Updating Controller
Firmware.”
To create a firmware diskette, obtain one DOS formatted diskette, and
follow these steps:
a.
Click
Create Support Software
.
b.
Click the plus sign (
+
) next to
Compaq
.
c.
Page down to
Options ROMPaq,
select it, and then click
Next
. Although
the onscreen instructions indicate that you need 10 diskettes, this
procedure creates only a single diskette. A screen for creating the
first diskette displays.
d.
Click
Skip
. The
Firmware Upgrade diskette for the RA4000 Controller
displays.
e.
Insert the formatted diskette into the disk drive, and then click
OK
.
f.
Wait for the software to be written to the diskette.
g.
Remove the diskette from the drive after the software has been
written to the diskette.
h.
Click
Skip
on each of the remaining screens, and then click
Finish
at the final screen to return to the
Compaq SmartStart-Manual Path
window.
26.
Remove the SmartStart CD and power down the node.
27.
Repeat the procedures for erasing a configuration (if necessary) and
configuring servers on node 2. Do not repeat step 25 on node 2.
If you have erased any existing configuration on both nodes of your server and
have configured both nodes with SmartStart, continue with the following
section, “Updating Controller Firmware,” to upgrade controller firmware.
