Removal and Replacement
5–14 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
5.12 OCP Assembly
Perform the following procedure to remove the OCP assembly:
1.
Extend the chassis for service (see Section 5.2).
2.
Remove the front panel (see Section 5.3).
3.
Remove the top cover (see Section 5.4).
4.
Remove the CPU modules (see Section 5.13).
5.
Remove the system card-cage fan assembly (see Section 5.16).
6.
Remove the front EMI/RFI honeycomb filter assembly (see Section 5.17).
7.
While reaching through the system card-cage fan area and holding the OCP assembly,
remove the four screws
that secure the OCP assembly to the front of the chassis and tilt
the OCP assembly back (see Figure 5-11).
8.
Remove the three push buttons
from the OCP by pulling them out (see Figure 5-11).
9.
Unsnap the OCP module
from the four standoffs that secure it to the OCP assembly
cover
(see Figure 5-11).
10.
Disconnect the OCP assembly ribbon cable
from the rear of the OCP module (see Figure
5-11).
To replace the OCP assembly, refer to Figure 5-11and reverse steps 1 through 10 of the
removal procedure.
Figure 5-11 Removing and Replacing the OCP Assembly
EA-00086
3
4
5
1
2
Summary of Contents for ES40CSLP
