Removal and Replacement
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 5–11
5.10 Hard Disk Drive
Perform the following procedure to remove a hard disk drive:
1.
Extend the chassis for service (see Section 5.2).
2.
Remove the hard disk drive cover (see Section 5.9).
3.
Disconnect the data
and power ¡ cables from the connectors on the top of the hard disk
drive (see Figure 5-9).
4.
Loosen the two captive screws
on the top of the hard disk drive bracket (see Figure 5-9).
5.
Pull the hard disk drive and bracket up and out of the hard disk drive bay.
6.
Remove the two screws
that secure the two rubber grommets to the lower sides (one
on each side) of the hard disk drive (see Figure 5-9).
7.
Remove the four screws
through the four rubber grommets that secure the hard disk
drive
to the hard disk drive bracket (see Figure 5-9).
8.
Remove the four rubber grommets
from the four slots on the sides (two on each side) of
the hard disk drive bracket
.
To replace the hard disk drive, refer to Figure 5-9 and reverse steps 1 through 8 of the removal
procedure.
Summary of Contents for ES40CSLP
