Compaq A3000, Getting Started

Page: 48 / 68

•
•
•
•
•
Chapter 6 44
• If the print quality of both lines is not satisfactory
after running the test three times, wipe the print
cartridge nozzles. For help, see the next section.
Wiping print nozzles and contacts
If print quality does not improve after cleaning the print
nozzles (see page 43), you may need to wipe dried ink from
the nozzles.
The nozzles are located on the bottom of the ink cartridge.
To desolve any dried ink, hold a damp cloth against the
nozzles for about three (3) seconds. Gently blot and allow
to dry.
To clean the contacts on the back of the cartridge, gently
blot with a damp cloth and allow to dry before replacing.
Preserving print cartridges
To ensure the longest life from your print cartridges and
optimum performance from your A3000:
• Keep a new print cartridge in its packaging until you are
ready to install it.
•
Do not remove a print cartridge except to replace, clean,
or store it in an air-tight container. The print cartridge
will not print correctly if removed from the A3000 and
left exposed for an extended period of time.
•
If a print cartridge runs out of ink, leave the empty
cartridge in the A3000 until you are ready to replace it.
Printing with one of the print cartridge carriers empty
may reduce the life of your printer.
Compaq does not recommend the use of refilled cartridges.
Refilling cartridges can affect print quality and cause
damage to the A3000. For best results, use Compaq
recommended supplies. Compaq’s Limited Warranty does
not cover repair of failures or damage caused by a refilled
cartridge.