2-30
Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
For use with Pentium II and Pentium III Xeon processor-based servers only
Peripheral Board
The peripheral board is removed for replacement, to access the connectors and switches on the
board, or to access the system I/O board. To remove the peripheral board:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the side access panel. See "Side Access Panel" earlier in this chapter.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you are
properly grounded before beginning any installation or removal procedure. Refer to the section
titled “Electrostatic Discharge” for more information.
3. Remove all cables from the back of the peripheral board.
;;
yy
;
y
;
y
;
y
;;
yy
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
y
;
;
y
y
;
y
;;
;;
yy
yy
;
y
;
;
y
y
Figure 2-24. Removing cables from the back of the peripheral board
4. Disconnect all cables from the peripheral board.
5. Loosen the two spring-loaded screws using a Phillips screwdriver.
Summary of Contents for 5500R - ProLiant - 256 MB RAM
Page 6: ......