Diagnostic Tools
3-57
For use with Pentium II and Pentium III Xeon processor-based servers only
Booting into Compaq Utilities
When you enable ASR-2 to start into Compaq Utilities and a critical error occurs, the operating-
system-specific Health Driver logs the error information in the Critical Error Log or the IML
and the ASR-2 feature restarts the server. When the system reinitializes, the system pages the
designated administrator (if enabled), and starts Compaq Utilities from the hard drive.
If Dial-In status is enabled, the modem is placed in auto-answer mode. If you enable Dial-Out
status, you are automatically enabled for Dial-In.
If Network Status is enabled, the appropriate network support software is loaded, depending on
the network protocol, IP or IPX. This allows remote access via the network.
IMPORTANT:
Compaq Utilities are loaded from a specially created system partition on the hard drive.
This partition was configured during server configuration.
You can access the server and view the Server Health Logs (in servers not supporting the IML)
remotely by modem, in-band over the network, or directly from the server. For modem access,
you must have either Compaq Insight Manager 2.0 or above or have a VT100 or ANSI terminal
type device. You may use a standard CRT with VT100 or ANSI emulation capability, or you
may use a PC with a VT100 or ANSI terminal emulation package. The communication
parameters must be set for 8 data bits, no parity, and 1 stop bit.
You can also enable ASR-2 to allow network access using the Network Status feature in the
System Configuration Utility. You must have either Compaq Insight Manager 2.0 or greater or a
Novell Virtual Terminal (NVT) emulator on an IPX network to use this feature. You must also
have version 2.24 or later of the System Configuration Utility. For IP access, you must have
Compaq Insight Manager 2.10 or later, or a Telnet Terminal emulator to use this feature. You
also must have version 2.24 or later of the System Configuration Utility.
The System Configuration Utility settings should resemble the settings in Table 3-24 when you
enable ASR-2 to start into Compaq Utilities.
Table 3-24
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Pager Data
Setting
Description
Pager status
Enabled
Indicates if the pager feature is enabled or disabled.
Pager dial
string
ATDT
555-5555
Indicates the pager dial string and delay before the pager message.
Pagers typically use one of the following formats:
Local pagers: ATDT 555-5555
Wide area pagers: ATDT 1-800-555-5555,1234567#
Pager message
1234567#
Represents a unique number (maximum seven digits, numeric only) that
you must designate to identify the server on the pager display. The ROM
adds a three-digit code to the front of this number. The first two indicate
the subsystem and the third indicates the severity of the error that
caused the alert. The # symbol usually terminates the message. If no
message is required, delete the # symbol.
continued
Summary of Contents for 5500R - ProLiant - 256 MB RAM
Page 6: ......
