Command Light CL605, User Manual, Page: 23 / 46

USER GUIDE
23
Troubleshooting
Problem Possible Cause Solution
Unit will not extend No power to the unit Check power input
connections.
Incorrect installation Refer to installation
instructions.
Upper stage will not rotate Lower stage not raised
above 16
"
Raise lower stage higher.
Rotation motor failure. Consult with factory.
Lights will not illuminate. Lower stage not raised
above 16
"
Raise lower stage higher.
Circuit breaker tripped. Check circuit breaker at
power supply.
No power to the unit. Check power supply
operation/output.
Lamp filament broken. Replace lamp.
Rotation coasts after
switch is released Drive chain out of
adjustment Adjust chain to provide no
more than ¼
"
slack
Unit will not nest Upper stage not centered Raise lower stage higher
than 16
" . Center upper stage
(green light illuminated)
Unit being operated on a
slope >10° Lower upper stage to
horizontal. Using a pike
pole, hold unit level while
lowering to nest position.
Autopark button must be
held in to park unit Improper or faulty ground Check nest sensor for
power and activation. Test
red/green wire for 12VDC.
Water in electronics Remove moisture from
ground points and
electronics. Do not use a
pressure washer to clean
unit.
Upper Act. & Rotation
Start at the same time Check down limit sensor. Contact factory for
replacement part.
Wires on back light
catching Check for 90 degree sealing
connector on lamp tree. Contact factory for
replacement part.
No lights or rotation Check safety limit switch,
bad, etc. Contact factory for
replacement part.
Autoparking off Center Center switch out of
adjustment Refer to instructions
on page
Popping noise coming
from back light Drive belt loose, switch
hoods stuck, faulty rotation
relay. Adjust belt for minimal
play. Replace switch hoods.