Command Light CL605, User Manual, Page: 11 / 46

USER GUIDE
11
Returning the light to the nested position
The COMMAND LIGHT is equipped with an Autopark function as a standard feature. The
“P” on the control box initiates the Autopark sequence. Once initiated, the “Emergency
Stop” red button indicator is illuminated. Pressing the “Emergency Stop” button will cancel
the Autopark sequence.
Autopark Sequence
Press “P” button on the controller once. It does not need to be held in position. The
Autopark sequence begins:
1. “Emergency Stop” light is illuminated.
2. Lamps are extinguished.
3. Upper stage begins rotation to the center position. If equipped with back light option,
back light begins rotation and returns to the home position.
4. Once upper stage is centered, rotation stops, lower stage begins retracting.
5. After lower stage has fully retracted, upper stage begins retracting. Upon upper
stage retracting fully, “Emergency Stop” light turns off. Controller will need to be
re-energized after “Emergency Stop” or nest is activated.
Installation
The COMMAND LIGHT must be installed by a designated installation facility by qualified
personnel only. All safety precautions must be thoroughly understood before installation.
Please consult the factory for additional installation information assistance.
Installation Kit
Included with the COMMAND LIGHT is an installation kit. Verify that the kit contains the
following items:
(1) 50 feet of 8GA-4 Conductor power cable (1) 50 feet of 22GA-20 conductor cable
(1) Pre-wired HOLSTER BOX w/cover
(1) Handheld Controller
(1) Lifting sling
(1) Small hardware parts bag with:
(4) mounting spacers (4) 3 ⁄
8
-16 X 2 ½
"
bolts
(4)
3
⁄
8
-16 nylon lock nuts (8)
3
⁄
8
" flat washers
(4) large diameter flat washers (2) ¼ -20 X
5
⁄
8
" Phillips pan head machine screws
(4) ¼ " flat washers (2) ¼ -20 nylon lock nuts
(1) ½
"
90° sealing connector w/nut (1) 1
"
90° sealing connector w/nut
(4) screw pin clevis