Command Light CL605, User Manual, Page: 19 / 46

USER GUIDE
19
Rotation Motor Replacement
1.) Raise the lamp tree fully. Loosen the center
switch screw. Take off the midplate covers.
Carefully remove the smaller cover, maneuvering
around the Turck sensor and wire.
2.) Loosen the motor screws enough to slide back
and forth. Rotate the upper lamp tree and locate
the master link in the rotation chain. Position the
master link to an available and comfortable place
to remove. Once disconnected, remove chain.
Note:
The upper lamp tree will now rotate freely.
3.) Using a
3
⁄
32
allen wrench, Remove the two set
screws in the small sprocket. Gently pull off the
small sprocket.
4.) Remove the bottom motor box cover.
Carefully pull out the pole strip and all
connected wires.
5.) Follow the two motor wires down to the pole
strip and disconnect. Brown wire (negative)
red/white wire (Positive).
Note:
The same wires that come off the old motor
will be the same wires you use for the new
rotation motor.
Swap the wires from the old motor to the new
motor. Now the new motor can be installed.
Center Switch Screw