Command Light CL605, User Manual, Page: 12 / 46

COMMAND LIGHT
12
Tools Required
Lifting device (crane, forklift, block and tackle, etc.)
Sling for lifting (included with light)
Drill
3 ⁄
8
"
,
17 ⁄
64
"
drill bits
Hole punch for metal with
7
⁄
8
"
and
17
⁄
64
"
diameter capacity Phillips head screwdriver, #2
COMMAND LIGHT flat blade screwdriver (included with light)
9
⁄
16
"
and
1
⁄
2
"
combination wrenches and/or ratchet and
9
⁄
16
"
and
1
⁄
2
"
sockets
8" adjustable wrench Tongue and Groove Pliers
Wire stripper or razor blade knife Solder-less wire connector crimp tool
Silicone based gasket sealer, RTV™ recommended
Installation Notes
The COMMAND LIGHT weighs approximately 300 pounds. Use mechanical assistance to
lift the light into installation position such as a forklift or crane.
Use the provided sling to grasp the light.
Use the provided fender washers under the mounting surface to distribute the weight
load evenly.
When routing the connecting electrical wires take care to avoid sharp bends, hot
components or other hazards to the wire.
The COMMAND LIGHT is not designed to be operated in a raised position while the
vehicle is in motion. The COMMAND LIGHT includes warning circuit wiring to enable
a warning device.