Command Light CL605, User Manual, Page: 22 / 46

COMMAND LIGHT
22
Power Failure
The COMMAND LIGHT can be retracted manually if power to the unit is lost. If power
loss is temporary, reestablishing power may be easier than manually retracting the light.
Disconnect power source from the COMMAND LIGHT .
Rotate to center
Slowly apply pressure to the rotation platform to manually rotate to the centered position.
Trying to rotate the platform too quickly or with too much pressure can break the rotation
motor shaft. Be certain that you rotate the platform in the proper direction. The upper stage
can rotate a full 360˚. Generally you need to rotate the platform in the direction that requires
the least amount of travel in order to center the platform.
*Retract The Lower Stage First
Locate the silver plug located on lower actuator below the lower actuator’s motor. Use the
provided hex tool to remove silver plug. Be sure to not lose this plug. Use the same hex tool
inserted into the opening to drive the internal gears of the actuator. Be sure to replace the
silver plug after this actuator is fully retracted
Retract The Upper Stage
To access the upper actuator mechanism it is necessary to remove the main cover. Remove
the 16 screws using a #2 Phillips head screwdriver. There are 12 screws on top and 2 on
either end of the main cover. Use the same hex bit and method as above in “
Retract The
Lower Stage First ” to retract the upper actuator.
Backlight
*Slowly apply pressure to align lower lights with the fixed ones.