Command Light CL605, User Manual, Page: 17 / 46

USER GUIDE
17
Warning Device Installation
Tools Required:
•
3
⁄
32
"
Flathead Screwdriver
• Wire Strippers
• Small Torch or Lighter
Wire the gray 22-20 control cable wires to the small connectors using the wiring schematics
provided. There are 2 different schematics, one is the standard version and the other is the
version for dual control with wireless controllers or V-Mux control. The standard schematic
will be used for V-Mux or any other multiplex system if it is only being used for elevated
warning. A V-Mux wiring schematic and circuit board troubleshooting guide are included.
Detaching & Attaching the Controller
1.) Loosen the
small nut.
2.) Loosen
the large nut. 3.) Gently slide the
connector away
from the holster. 4.) Disconnect the
cable by pressing down
on the tab and pulling.
Make sure the tab on the ethernet (CAT 5) connector is in the slot before attaching the cord.
Lock the large nut, make sure the ethernet cord is pushed all the way in, lastly tighten the small
nut onto the cord.