Command Light CL605, User Manual, Page: 20 / 46

COMMAND LIGHT
20
6.)Attach the wires to the new motor (the brown is negative and the red/white is positive)
and connect them to the pole strip. Place the motor back into the housing and screw in all
four screws. Rotate the motor so the key stock slot is facing you.
7.) Place the small sprocket back on the motor
and put in the keystock. Use blue Loctite on the
set screws tightening them as much as possible.
8.) If not already, loosen up the four motor
screws to let the motor slip for adjustment.
Wrap the chain back around the sprockets
bringing the ends together.
Note:
Be sure the half-link is on the right hand side
with the small cotter pin facing upwards.
9.) Using a small pry bar or a screw driver, put
pressure on the small sprocket pushing it away
and tightening the chain. Tighten down the four
motor screws.
10.) Now the bottom box cover can be put back
on after placing all the wires back in place. The
mid plate covers can now be put back on also.
Note:
After motor replacement is completed, the
center switch and the safety switch will need
to be adjusted.