Command Light CL605, User Manual, Page: 14 / 46

COMMAND LIGHT
14
Mounting
Place the provided spacers in the location of the light mounting holes. The spacers may be
modified to conform to the contour of the mounting location.
Remove any obstructions below the mounting surface such as headliners.
Attach any necessary lifting attachments to the COMMAND LIGHT . The center of gravity
(balance point) is slightly behind the lower bank of lights.
Slowly lift the COMMAND LIGHT and check for balanced lifting. Lower and make any
necessary adjustments to the lift points.
Lift and place the
COMMAND LIGHT into
position above the
spacers. Before placing
the full weight of the unit
on the spacers align
spacers with the holes in
the end frame castings.
Drill
13
/
32
” holes in the
mounting surface using
the end casting holes as a
template.
Fasten the light using the
provided hardware. To
assure a weather-tight
installation apply a thin
bead of silicone based
gasket sealer to the base
of the spacer and
underside of bolt head.
Remove any lifting straps and devices from the COMMAND LIGHT .
Locate and drill the wire feed holes.
Control Box Holster Mounting
Using the holster as a template, mark hole locations.
Drill
17
/
64
" mounting holes.
Drill any holes required to route the control wire from the control box to the
COMMAND LIGHT unit. Mount holster box with provided hardware.