IE-SNC-P86xx-01
5
The device may be installed only in prescribed areas. Never expose the device higher or
lower temperatures than is allowed. The device has not improved resistance to moisture.
Protect it from dripping or splashing water and do not use at areas with condensation.
Don’t use device in explosive environments.
Don’t stress the device mechanically.
Device description and important notices
This chapter contains informations about basic features. Also there are
important notices concerning to functional safety.
Values from the device can be read using an Ethernet connection. The following formats
are supported:
Web pages with user changeable look
Modbus TCP protocol
SNMPv1 protocol
SOAP protocol
The device can also be used to check measured values and if the limit is exceeded, device
sends warning messages. Possible ways to sending warning messages:
Sending e-mails up to 3 e-mail addresses (SMTP authentication is not
supported in current firmware version)
Sending SNMP traps up to 3 configurable IP addresses
Displaying the alarm status on web page
Sending messages to Syslog server
The device setup can be made by the TSensor software or via Telnet. TSensor software can
be free downloaded from the manufacturer’s website. Also you will find there latest
firmware for your device.
If you want to use PoE, you must use PoE switch compatible with IEEE 802.3af standard.
As a low cost solution can be recommended Repotec switch RP-PE8T/4.
Reliability of warning messages delivering (e-mail trap), depends on actual
availability of necessary network services. The device should not be used for
critical applications, where malfunction could cause to injury or loss of human
life. For highly reliable systems, redundancy is essential. For more information
please see standard IEC 61508.
Never connect the device directly to the Internet. If it is necessary connect the
device to the internet, properly configured firewall must be used. Firewall can
be partially replaced with the NAT.
Summary of Contents for P8610
Page 26: ...IE SNC P86xx 01 26...
Page 27: ...IE SNC P86xx 01 27...
Page 28: ...www cometsystem cz...
