Comet System P8610, User Manual

Page: 16 / 28

IE-SNC-P86xx-01
16
Modbus device registers. Address could be by 1 higher, depending on type used
communication library:
Address [DEC] Address [HEX] Value Type R/W
40000 0x9C40 channel 1 temperature Int*10 R
40001 0x9C41 channel 1 alarm status Ascii R
40002 0x9C42 channel 1 upper limit Int*10 R/W
40003 0x9C43 channel 1 lower limit Int*10 R/W
40004 0x9C44 channel 1 hysteresis Int*10 R/W
40005 0x9C45 channel 1 delay uInt R/W
40006 0x9C46 channel 2 temperature Int*10 R
40007 0x9C47 channel 2 alarm status Ascii R
40008 0x9C48 channel 2 upper limit Int*10 R/W
40009 0x9C49 channel 2 lower limit Int*10 R/W
40010 0x9C4A channel 2 hysteresis Int*10 R/W
40011 0x9C4B channel 2 delay uInt R/W
40012 0x9C4C channel 3 temperature Int*10 R
40013 0x9C4D channel 3 alarm status Ascii R
40014 0x9C4E channel 3 upper limit Int*10 R/W
40015 0x9C4F channel 3 lower limit Int*10 R/W
40016 0x9C50 channel 3 hysteresis Int*10 R/W
40017 0x9C51 channel 3 delay uInt R/W
Description:
R read only register
W register is designed for write
Int*10 registry is in format integer*10 – 16 bits
uInt registry range is 0-65535
Ascii character
Possible alarm states:
no no alarm
lo value is lower than set limit
hi value is higher than set limit
SOAP
The device allows you to send currently measured values via SOAP v1.1 protocol. The
device sends values in XML format to the web server. The advantage of this protocol is
that communication is initialized by the device side. Due to it is not necessary use port
forwarding. Sending interval can be set in range 10-65535s using TSensor software. If the
SOAP message can not be delivered, warning message via SNMP Trap or Syslog protocol
is sent. The file with the XSD schema can be downloaded from:
www.cometsystem.cz/schemas/soapP85xx_v2.xsd
.
SOAP protocol uses monitoring software DBS Sensor monitor. This software can be
purchased as optional accessories.