22
See assembly sequence on page 41.
Locate the area with the tamper support, with the pre-marked
break-off panel for facilitating detachment of the tamper, and
remove the silicone key acting as a tamper. Put it in a clean
place.
The base of the keypads, both with and without RFID reader,
has a series of slots in it to ensure versatility of mounting on a
wide range of supports, starting with the ordinary type 503 box.
See assembly sequence on page 41.
IMPORTANT: when closing the housing, remember to refit
the tamper in its place. The black, conductive part must
be visible.
Fixing on box 503
Wall mounting
The base of the keypads, both with and without RFID reader, has a series
of slots in it to ensure versatility of mounting on a wide range of supports,
starting with the ordinary type 503 box.
Fixing holes*
Elastic closure clips
Position of silicone tamper
Anti-tear tamper hole
Cable routing
TECHNICAL SPECIFICATIONS
SETTING RFID READER SPEED
IMPORTANT:
At first start-up, the RFID reader is ready to
communicate at 38400 baud rate. To modify the communication
speed, proceed as follows:
1.
With the device powered up, set DIP switch 6 to ON. The
LEDs on the RFID will light up until they are all lit, and will
then all go off and start lighting up again (learning mode)
2.
In this condition, set Dip Switches 1 and 2 (as indicated in
the table to configure the desired speed)
3.
Once you have set the speed, set DIP switch 6 back to OFF.
The speed is now set.
4.
Set DIP switches 1 to 5 according to the address to be set.
Note that the standard speed of the bus for VEDO control
panels is 38400 baud.
Features
Value
Name of manufacturer / supplier
Comelit Group S.p.A.
Dimensions (b x h x d)
55 x 48 x 19 mm
Weight
28g
Consumption (min./max.)
10mA in Idle status
15mA with LEDs on
45mA during key reading
Operating voltage
10 - 15 V
Operating temperature
-10° / + 40° C
Operating humidity
max +85% (not condensed)
Device Type
B according to EN50131-3
Environmental class
Environmental class II
3.7.2 RFID proximity reader on bus (Art.
VEDOPROX)
The RFID proximity reader on bus allows activation and
deactivation with RFID keys without contact. An RFID key can
be associated to each user. Each key can operate on the zones
and areas for which the associated user is enabled.
Its mechanical configuration is such that it can be used directly
on all residential series that use an adapter for Keystone
standard RJ45 network connector. It is compatible with Comelit
RFID keys.
• Simplified mounting with Keystone generic RJ45 adapter on
residential series frames.
• Four LEDs with partially assignable functions.
• Quick total activation option.
• Choice of several activation modes.
• Physical addressing of device by means of DIP switches.
MAIN FEATURES
Baud
DIP 1
DIP 2
9600
OFF
OFF
38400
ON
OFF
57600
OFF
ON
115200
ON
ON
In order to guarantee Grade 2 certification according to EN50131-1
the tamper must be mounted and configured correctly
MOUNTING THE KEYPADS
