13
3.3 CONTROL PANEL CARD ART. PCBVEDO10,
ART. PCBVEDO34, ART. PCBVEDO68
The control panel card is available in 3 versions with different
features, see the table on page 5 for the detailed features of the
control panels VEDO10, VEDO34, VEDO68, VEDO34M, VEDO68M
which include the respective control panel cards (PCBVEDO10,
PCBVEDO34, PCBVEDO68, PCBVEDO34, PCBVEDO68)
The card has a basic configuration with 8 freely programmable zones
+1 sabotage zone. It has a relay output, which by default, manages the
sirens, and 2 low-consumption programmable outputs.
The control panel card is supplied with a built-in digital dialler, which
allows the transmission of voice messages by means of an additional
audio/voice control module.
It is equipped with 8 standard wired zones and one anti-tamper zone.
It also has one relay output and 2 configurable 100 mA open-collector
outputs.
The association of zones to areas and partial subgroups of areas
allows total, partial or selective activation of the system, according to
the authorisations assigned at the configuration stage to the user who
performs the operations.
Each input event can be associated with multiple outputs, thus
potentially involving all the outputs configured at the installation stage.
The flexibility of this arrangement makes it possible to adapt the control
panel to the most wide-ranging requirements.
3.3.1 Main features
• 0.75A / 13.8 V self-resettable fuse for protecting the power
supply to the siren outputs
• 1.5A / 13.8 V self-resettable fuse for protecting the power
supply to the RS485 buses
• 1.5A / 13.8 V self-resettable fuse for protecting the power
supply to the sensors
• all the inputs are filtered and protected against electrical and
electrostatic discharges
• alarm relay with potential-free exchange contact 24V= 3A
• 2 programmable logic outputs with configurable polarity,
limited to 100mA, self- resettable
• built-in digital dialler
• separate power supply unit, switching type direct from mains
• power supply protection against overloads, short-circuits
and voltage surges
• battery connection (up to 18 A/h hours –12V) protected
against reversed polarity and short-circuits
• circuit for dynamic testing of backup battery charge state
• circuit for monitoring the positive siren voltages, 485 bus
and sensor auxiliary positive
• on-board 485 bus terminal resistor, which can be activated
by means of a jumper
• USB interface for connection to a configuration system
The control panel card complies with standards EN50131-1
and EN50131-3
Holes for fixing the control panel card to the metal housing Art. BOXMETAL
Fixtures for cards/expansions
JP4
JP5
JP8
JP1
CN4
MOD2
MOD1
V+
AUX
V+
AUX V- 24H
I1
I2
I3
I4
I5
I6
V-
I7
I8
V-
MOD3
JP6
JP7
JP3
JP2
MOD5
CN1
CN2
L1
M11
M2
M3
M4
M5
M6
M7
M8
M10
M9
M12
L2
TEL2
TEL1
V+
BUS
A
B
V-
COM
NC
NO
V+
SIR
TC2
TC1
V-
CN3
DL5
DL1
DL4
DL3
DL2
IP COMMUNICATION
MODULE POSITION
GSM COMMUNICATION
MODULE POSITION
CARDS POSITION
FOR FUTURE USES
MESSAGES
EXPANSION
POSITION
Fig Scheda Centrale
