47
WORK
2.
Raise the squeegee off the ground, turn the lever (02) clockwise.
3.
After about 15-25 seconds turn the key (03) 1/4 of a turn left, this will stop the machine.
4.
Turn the key (03) 1/4 of a turn right, this will start the machine.
ATTENTION: During machine switch-on, do not keep the accelerator pedal pressed
down.
5.
Bring the machine to the designated place for draining off the dirty water, and empty the
recovery tank (refer to “DRAINING THE RECOVERY TANK”).
WARNING! It is good practice every time the solution tank level is topped up, to
empty the recovery tank using the special drainage hose.
45. OVERFLOW DEVICE (Innova 65B - Innova 75B - Innova 85B - Innova 100B - Innova 70S -
Innova 70BTO versions)
The machine is NOT equipped with an overflow device, because the capacity of the recovery tank
is greater than the capacity of the solution tank. In extraordinary cases, there is a mechanical
device (float) under the recovery tank lid that, when the recovery tank is full, shuts off the air to the
vacuum motor intake to protect it; the sound of the vacuum motor will then be deeper.
If this is the case, proceed as follows:
1.
Using the switch on the instrument panel select the “TRANSPORT” program (A), in this way
the brush motors and the solenoid valve will stop working, after a few seconds the brush
head unit will lift up from the floor. The squeegee will remain in contact with the floor for a
few seconds, to allow the drying to finish, after which it will lift up off the floor. A few
seconds after the squeegee is in the rest position the vacuum motor stops working, this is
to allow all the liquid in the vacuum hose to be suctioned off.
2.
Bring the machine to the designated place for draining off the dirty water, and empty the
recovery tank (refer to “DRAINING THE RECOVERY TANK”).
WARNING! It is good practice every time the solution tank level is topped up, to
empty the recovery tank using the special drainage hose.