Page | 37
VASTRAJET
Step 6:
Fix the
Ink Sub Tank
pipe into the other end of the
Ink Inlet
(Refer to Fig 41).
Step 7:
Remove the cap of the
Air Releasing Pipe
(Refer to Fig 41).
Step 8:
Hold the
pipe down
and press the
Purging
button of a particular color.
Note:
Carefully perform the above step to avoid the chances of ink spilling.
Additionally, perform the same action for all colors and release ink up to 5ml.
Step 9:
Simultaneous, release the purging button and cap the
Air Releasing Pipe
.
Step 10:
Insert one end of the head cable on the top of the Print Head by following the arrow mark.
Note:
While inserting the head cable, the machine must be Switch OFF.
Step 11:
Similarly, insert the second end of the head cable on the Head Board. The block diagram for head
installation is shown as below:
Fig 42: Block Diagram for Head Installation
To verify the head cable orientation, please carefully view the highlight area on the above image.
Step 12:
Check whether the
Waste Bottle
is attached or not.
Step 13:
Perform the
Head Purging
for all colors.
Step 14:
Perform the
Head Blotting
to gently clean the Print Head.
Step 15:
Perform the
Nozzle Test
to check the nozzle status of all the Print Heads.
Now, the Print Head gets installed.
Head Connectors
Head Cables
Head Plate
Head Board
