Page | 23
VASTRAJET
o
When the belt is rotated reversely (without adjusting), further shifting is stopped and belt
starts moving in opposite direction. Closely monitor the process until it comes in the center.
Once belt has positioned centrally, glue cycle has to be stopped and shifting control
adjustment has to be done as mentioned further in next section.
•
If the belt shifting has crossed 5mm outside the roller, print has be stopped immediately and belt
has to be repositioned in center by loosening the tensioner screws, else severe damage to belt can
happen. If you feel unconfident about doing so, please call the engineer.
Belt shifting control
Below procedure explains about the Conveyor Belt shifting control.
•
Belt shifting can be controlled ‘on the fly’ as well as when print is stopped.
•
To control the position of Adjust Roller, turn the Toggle switch into FWD/REV direction (The Toggle
Switch is available backside of the HMI) as per the requirements.
Case-I: Belt Shifted Towards Left
