Page | 72
AuraJet Series II
Case 6
: Replace the Pump if required
Procedure:
Steps to replace the pump:
a.
Remove the IN and OUT pipes from the pumps, as shown below:
Fig 88: Displaying Pump Pipes and Bracket Screw
b.
Remove the IN and OUT connectors gently, as shown below:
Fig 89: Displaying IN & OUT Connectors
c.
Remove both screws on the Pump bracket (Refer to Fig 89).
d.
Remove all the screws (four screws) available on the back side of the Pump bracket.
e.
Remove the pump careful and replace it by reversely following all the above mentioned steps.
Note
: While connecting the IN and OUT connectors, carefully observe the IN and OUT signs.
IN & OUT Pipes
IN & OUT Connectors
Summary of Contents for AURAJET II Series
Page 1: ......
Page 18: ...Page 17 AuraJet Series II Step 17 Install the sublimation kit If applicable as shown below...
Page 79: ......
