Page | 69
AuraJet Series II
Case 3
: Correct Motor parameters.
Case 4
: Replace LM block, if required.
Procedure:
Steps to replace the LM Block:
a.
Disengaged the Capping Unit.
b.
Switch OFF the printer.
c.
Remove the front and top covers of the Carriage.
d.
Remove the Y connectors from the Pipe Separator Unit, as shown below:
Fig 85: Displaying the Y Connector
e.
Remove the Print Head gently.
f.
Remove the Encoder Sensor by removing the Pipe Separator Unit and Encoder Screws, as shown
below:
Fig 86: Removing the Encoder Sensor Screws
Y Connector
Summary of Contents for AURAJET II Series
Page 1: ......
Page 18: ...Page 17 AuraJet Series II Step 17 Install the sublimation kit If applicable as shown below...
Page 79: ......
