Page | 62
AuraJet Series II
Remedial Actions:
Case 1
: Perform the Nozzle Test (Refer to the
Nozzle Testing
section).
Case 2
: Use the Feed Adjust option to adjust the feed value (Refer to the
Print Head Calibration
section).
Case 3
: Correct the alignment settings by following steps mentioned in the Head Alignment section.
Case 4
: Tighten the Connectors from both places viz. motor side and main board.
Case 5
: Check or replace the Grid Roller Shaft, if required.
Case 6:
Replace the Wiper.
Procedure:
Steps to replace the Wiper:
a.
Switch OFF the printer.
b.
Manually move the Wiper Unit to access it.
c.
Gently press the clip and pull up the Wiper Bracket, as shown below:
Fig 77: Pressing Wiper Brackets
d.
Lift the wiper from its position and pull it out from its bracket (Refer to above image).
Wiper Brackets
Summary of Contents for AURAJET II Series
Page 1: ......
Page 18: ...Page 17 AuraJet Series II Step 17 Install the sublimation kit If applicable as shown below...
Page 79: ......
