Product Manual
SDM09H-Hosereel Page 9
Issue 2
– April’20
90° RH HANDWIND
7700.0R.A
LH ANGLED
7705.0L.A
7705.0R.A
RH ANGLED
12 TEETH
26° REWIND
7700.0L.A
90° LH HANDWIND
SWING COVER
SIDEWAYS TO
GAIN ACCESS
TO REWIND
SHAFT
2.4
Handwheel Friction Brake
2.4.1
This brake is fitted to most hosereels as standard.
2.4.2
Rotating the handwheel clockwise will increase the strength of the brake. The brake should be
partially released when deploying the hose, whilst still providing sufficient friction to prevent overrun of
the drum. To rewind the hose the brake should be released further. When the hose is stored the
brake should be fully tightened to ensure that the drum cannot rotate during transit.
Figure 6
– Friction brake
2.5
Installing ancillary devices
Additional equipment may have been supplied with the hosereel. This may include but not be limited to the
following:
2.5.1
Fixed 4 way roller guides
These are designed to reduce hose wear. Make sure that the hose will run smoothly off the hosereel drum
and between the rollers.
Figure 7
– Fixed roller guides
4 - WAY TOP
FIXED
ROLLER
GUIDES
4 - WAY FRONT
FIXED
ROLLER
GUIDES
