Product Manual
SDM09H-Hosereel Page 16
Issue 2
– April’20
Equipment:
13mm A/F spanner and a new seal (check type is correct for your model of hosereel).
4.5.3.1
Drain the delivery hose and remove the inlet hose from the hosereel inlet.
4.5.3.2
Remove the 3 bolts and shakeproof washers securing the inlet and pull off the inlet to expose the
seal.
4.5.3.3
Remove the old seal from the end of the spindle, taking care not to scratch any of the sealing faces.
4.5.3.4
Wipe all parts clean and fit the new seal. O ring seals locate into the groove on the spindle, chevron
seals locate in the inlet.
4.5.3.5
Apply a little grease to the mating parts of the seal and carefully push the inlet back into position,
locate with the 3 bolts previously removed, taking care not to damage the seal.
4.5.3.6
Refit 3 bolts and tighten firmly, reconnect the hose to the inlet using an appropriate thread sealant
and check for leaks.
NOTE:
If leakage still occurs after replacement of the seals it is possible that other components of the
swingjoint are worn and may need replacement. Please identify your hosereel, see section 1.1 and
contact our Sales department for further assistance.
Figure 12
– Typical swingjoint / fluid path assembly (1½“ and 2”)
Key to parts
1
Spindle
2
Gooseneck
3
Bearing housing
4
Inlet
5
Shaft
6
Chevron seal (or o ring
– see appendix 4 and 5)
1
3
4
2
5
6
