Product Manual
SDM09H-Hosereel Page 19
Issue 2
– April’20
4.6
PROBLEM SOLVING
Table 1 - Problem solving
Problem
Possible fault
Corrective action
a.
Drum does not rotate
easily.
The handwind brake is engaged.
The drum bearings are not
lubricated.
The drive chains are too tight.
The frame was twisted when
mounted.
Rewind gears are not meshed
correctly.
Release handwind brake.
Apply grease to grease nipples.
Loosen the tension so that there is
13mm sideways movement. Check that
the sprockets are correctly aligned.
Loosen mounting bolts, place packing
piece under one corner of the frame and
retighten bolts.
Contact Collins Youldon for advice.
b.
Rewind is weak
Hydraulic set pressure too low
Check setting of controls see ‘c’ below
c.
Hydraulic drive not
rewinding
No hydraulic fluid flow
Faulty motor
A competent technician should check:-
Hydraulic drive control lever is in correct
position.
Pressure relief valve is set correctly
That there is hydraulic fluid in the
system
Flow control valve is working
Changeover valve is working
Replace the motor, section 4.4.2
d.
Product leakage
Leaks from swingjoint.
Make sure seals are not worn, replace
as per section 4.5
Swingjoint defective, replace part or
whole assembly as necessary, see
section 4.5
