AN 06/2003
page
1.1 GENERAL SAFETY INSTRUCTIONS
*)
Staff in charge of maintenance of the processor (see chapter 11and 12) need to be
thoroughly familiar with the equipment.
*)
Only the Top Cover of the Filmprocessor may be removed by the operator (see picture
below)
.
*)
The film processor must be separated from mains prior to carrying out any maintenance. To
do so, switch the mains switch of the machine to „0“ position. Always wear safety goggles
and protective clothing when handling chemicals.
*)
The filmprocesor may not be in operation without supervision.
*)
Make sure that clothing or other objects cannot get entrapped in gear drives or similar of the
film processor.
*)
The installation, service, repair as well as the initial operation of the machine may be carried
out by qualified and trained service personnel only.
*)
Built-in safety devices may not be eluded or made inoperative. Use only original COLENTA
spare parts when exchanging failed electrical components.
*)
Do not wear any loose necklaces or bracelets!
1.2 CHEMICAL HANDLING
*)
Observe all safety technical regulations of the chemical manufacturer.
*)
Wear safety goggles and protective clothing when handling chemicals.
*)
Ensure proper ventilation of the room in which the chemicals are prepared.
*)
Spillage or overflow of chemicals has to be removed instantly.
*)
In case of contact with the eyes flush with plenty of cold water for approximately fifteen
minutes and consult an physician.
*)
Chemical disposal has to be in accordance with the local environmental codes. Contact your
local water treatment and sewer district authorities for more information.
Top covers
Main switch of
the film processor
2
