AN 06/2003
page
The software is equipped with a sub-program to contol the filter - when required.
That means after xxm² processed material, the controller will supply the message
"
CHANGE FILTER
" - now the filters has to be cleaned / or replaced.
After the filter are new, the counter must be set to zero. To do that, follow the steps
described below:
Press the bottum
3
, you will see
use
6
to move the courser under
"
Options
", and confirm with
7
, you will get
use again
6
to
move the cursor to "Filter", confirm with
7
you will see:
The
Area menu
sets the amount of square meters before filter alert.
The value is 0000-9999 . A value of 0000 turns off the filter alert. (50m²)
Filter alert
after xxxx sqm
Save Cancel
The
Log menu
shows the total processed media area.
0000.00
Exit Clear
After the filter is cleaned, the operator needs to reset the counter to zero. This is
important for confirming the next filter interval.
28
Area
Log
11.10 FILTER CONTROL
Area
Log
Program Setup
Options
Standby Filter
