AN 06/2003
page
11.8 AUTOMATIC START
The processor will start automatically when media is under the sensorbar, except when an
ERROR is active (see list of error messages):
26
11.6 MANUAL START/STOP
The manual start/stop is only possible when no media is in process. During processing
the corresponding menu items cannot be selected.
To run the motor manually:
Press
5
,
use
6
,
move the cursor under
Start
and confirm with
7
.
This will start the motor, pumps and dryer unit. The menu item
Start
will change to
Stop.
Stop the motor by confirming
Stop
again with
7
When the motor was started manually, the display will indicate this on the main page by
showing
M1
instead of
P1.
11.7 SWITCHING ON/OFF THE DISPLAY ILLUMINATION
I
n a dark room, it might be necessary to switch off the display backlight to prevent
any exposure on the paper . The
1
button toggles the backlight on/off.
When the backlight is off, all the buttons except
1
are disabled.
This is necessary to prevent pressing buttons on the panel by mistake in the dark room.
Switching the display off is a good idea when the processor is left unattended. This will reduce the
chances for unauthorized people operating the processor.
P1 Film in
If there is an ERROR,
the display will show you for
example :
Tank3 too cold
In that case, remove the media from the input section, check the error which is shown,
and feed again.
