Cole Parmer MB-200-40, Instruction Manual

Page: 12 / 60

Page 9 of 60
•
Protect the Moisture Analyzer from external liquids. Clean any spills
immediately.
•
If there is any visible damage to the Moisture Analyzer or the power cable,
stop using the instrument immediately. Unplug the power and isolate the
analyzer. Do not use until the faults have been repaired.
•
All repairs must be done by a trained technician. There are no user
serviceable parts in the enclosure.
HOT SURFACES
•
During test the cover of the heating chamber can become very hot,
especially near the top vent. Keep all material away from the vent area. Do
not touch hot surfaces.
•
Leave 20 cm (about 8 inches) around the moisture analyzer and 1 m (3
ft.) above.
•
Samples will be hot after a test. Do not use bare fingers to pick up any
samples pans or touch the materials. The internal surfaces of the weighing
chamber may be hot for some time after a test.
MATERIALS
•
The Moisture Analyzer is not suitable for all materials. During the drying
process samples will be heated to high temperatures. Materials that are
flammable or explosive should not be tested.
© 2022