Connect to an Ethernet Network
Connect one end of the 10/100/1000 RJ-45 Ethernet cable into the vision controller's LAN port. Connect the other end of
the cable to an Ethernet network adapter or switch, as applicable.
Note
: To avoid electromagnetic interference, the Ethernet cable must be shielded. Cognex strongly recommends
CAT5E Ethernet cables with S/STP shielding.
Insert the SD Card (Optional)
Note
: SD cards should be USH-I or USH-II and formatted with a FAT32 file system.
1. Lift the hinged door covering the SD card slot.
2. Insert the SD card into the SD card slot, ensuring the card is properly oriented.
Connect to a Display (Optional)
CAUTION
:
Cognex recommends only cold-plugging the HDMI cable and display; turn the vision controller power
off when connecting or disconnecting the HDMI cable.
Note
: To avoid electromagnetic interference, the HDMI cable must be shielded. A shielded Cognex accessory
HDMI cable (P/N 300-10006-xR) is available for purchase separately.
1. Connect a locking HDMI cable to the vision controller's VIDEO OUT port and tighten the thumb screw to secure it
to the vision controller.
2. Connect the other end of the cable to the display.
25
Installation
