Install the Lens
1. Remove the protective film covering the threaded lens opening, if present.
2. Attach a C-Mount lens to the camera. The exact lens focal length needed depends on the working distance and
the field of view required for your machine vision application.
Connect the Breakout Cable (Optional)
The camera's I/O connector provides access to the STROBE and COMMON lines on the camera.
Note
:
l
I/O wiring or adjustments to I/O devices should be performed when the camera is not receiving power.
l
The Ethernet cable should be unplugged or the PoE source powered down before making adjustments to
the connections at the far end of the Breakout cable.
l
Unused bare wires can be clipped short or tied back using a tie made of non-conductive material.
1. If installing the ISC-8405 camera, attach the ferrite around the Breakout cable, adjacent to the strain relief on the
cable.
CAUTION
:
A ferrite is included with the ISC-8405 camera standard components. To reduce emissions, the
ferrite must be attached to the Breakout cable.
2. Connect the Breakout cable's M8 connector to the camera's I/O connector.
21
Installation
