Camera Connectors and Indicators
ISC-8402
ISC-8405
Connector/Indicator
Description
ENET LED
1000-BaseT: LED turns on when the camera is receiving power during startup, and blinks
green once network traffic is detected.
100-BaseT: LED turns on when the camera is receiving power during startup, and blinks green
and red (appears orange) once network traffic is detected.
10-BaseT: LED turns on when the camera is receiving power during startup, and blinks red
once network traffic is detected.
LED 1
Green when active.
LED 2
Red when active.
I/O Port
The I/O port is an M8 port that provides connection to the strobe output via the Breakout cable.
For more information, refer to
ENET Port
The ENET port is a 10/100/1000 port that provides Gigabit Ethernet connectivity and supplies
Power over Ethernet (PoE) via the Ethernet cable. For more information, refer to
Cable Specifications (ISC-8402)
and
Ethernet Cable Specifications (ISC-8405)
Note
:
l
When initially powered up, the ENET LED turns on and is orange and LED 1 turn on and is steady green for
approximately 10 seconds. Next, LED 2 flashes green and then red, and then both LED 1 and LED 2 turn
off. Next, the ENET LED turns off and then momentarily flashes when a network connection is established,
and then begins blinking once network traffic is detected.
l
If both LED 1 and LED 2 are solid red, the camera's firmware update was interrupted.
16
Introduction
