Cognex In-Sight 5000 Series, Installation Manual

Page: 19 / 48

Connect the Breakout Cable
Note : Unused bare wires can be clipped short or tied back using a tie made of non-conductive material.Keep all
bare wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply being used is unplugged and not receiving power.
2. Optionally, connect the I/O or serial wires to an appropriate device (for example, a PLC, an encoder, or a serial
device). For more information, refer to Breakout Cable Specifications on page 22 .
Note : When using an In-Sight 5604 line scan vision system, the RS-232RX wire is used as Encoder A and
the RS-232TX wire is used as Encoder B. For more information, refer to Encoder Inputs (In-Sight 5604 Only)
on page 18 .
3. Attach the I/O Breakout cable's +24VDC (White/Green wire) and 24V COMMON (Brown wire) to the
corresponding terminals on the power supply. Refer to Breakout Cable Specifications on page 22 for wiring
details.
CAUTION : Never connect voltages other than 24VDC. Always observe the polarity shown.
4. Attach the Breakout cable's M12 connector to the vision system's 24VDC connector.
Figure 2-3: Power Connections
5. Restore power to the 24VDC power supply and turn it on if necessary.
Installation
7