Cognex In-Sight 5000 Series, Installation Manual

Page: 34 / 48

Breakout Cable Specifications
The Breakout cable provides connection to an external power supply, RS-232 serial communications, acquisition trigger
input, high-speed outputs and encoder inputs (In-Sight 5604 only). The Breakout cable is not terminated. When using the
In-Sight 5604, refer to Encoder Inputs (In-Sight 5604 Only) on page 18 .
Table 3-9: Breakout Cable Pin-Out
Pin# Signal Name Wire Color
1 +24VDC White/Green
2 Green
3 TRIGGER- White/Orange
4 HS OUT 0 Blue
5 HS OUT 1 White/Blue
6
RS-232 RECEIVE (RxD)
1
(In-Sight 5604 Only: Encoder A)
Orange
7
RS-232 TRANSMIT (TxD)
2
(In-Sight 5604 Only: Encoder B)
White/Brown
8 24V COMMON Brown
Note :
l
Cables are sold separately.
l
Unused bare wires can be clipped short or tied back using a tie made of non-conductive material. Keep all
bare wires separated from the +24VDC wire.
l
The housing of the vision system is internally connected to the system ground wire (pin 8 of the Breakout
cable). Therefore, if the mounting surface of the vision system is at a non-zero ground potential, it is strongly
recommended that the vision system be mounted on an isolated or non-conductive mount.
1
If hardware handshaking is required, an I/O module must be used.
2
If hardware handshaking is required, an I/O module must be used.
22