Setup with the web interface for PC
4-10
Chapter 4: Setup and operation
98-143492-D
4. Click the arrow buttons for Azimuth or Elevation to change the offset. The current
position is shown on the screen.
There is also a reset button for resetting the azimuth and elevation offset. An offset of 0
corresponds to the current position.
4.1.6
Navigation
In this section you can set Heading, Position, Manual pointing and Fixed installation.
•
Heading:
You can enter a fixed base heading if magnetic disturbances in the area cause
a misreading of the internal compass.
•
Position
: You can enter a fixed position if the position provided by the internal GNSS
module is not sufficiently good or you do not want to wait for a GPS fix.
•
Manual pointing:
This turns off the motors in the antenna and you must make a
manual pointing using the hand crank.
•
Fixed installation:
Selected this if the EXPLORER 5075GX is set up as a fixed
installation, i.e. when the EXPLORER 5075GX will not move over time and where access
to the EXPLORER 5075GX is not intended and/or difficult.
Do as follows:
1. Select
SETTINGS > Navigation
from the left navigation pane.
Figure 4-8: Web interface: SERVICE > Navigation
